Mercedes-Benz Unimog U4000 Euro 5

DIMENSIONS with 335/80 R 20 tires
Overall height – 2,650 mm
Overall width – 2,490 mm
Track – 1,927 mm
Ground clearance – 423 mm

Wheelbase – 3,250 mm (model variant 437.421)
Overall length – 5,410 mm
Possible body length – 3,250 mm
Approach/departure angle – 41/44 degrees

Wheelbase – 3,850 mm (model variant 437.426)
Overall length with frame extension – 6,460 mm
Possible body length – 4,100 mm
Possible body length with frame extension – 4,600 mm
Approach/departure angle – 41/44 degrees

STANDARD EQUIPMENT
Engine

  • Turbocharger with intercooler
  • 2 control characteristics (on-road/off-road)
  • Manual throttle (electronic)
  • 2 viscous fans with V-belt drive
  • Euro 5 emissions standard
  • 2-stage engine brake (constantly open throttle/throttle valve)
  • Air compressor 310 l/min
  • Air dryer
  • Air filter, moisture separator
  • Cold start down to -18°C
  • Maintenance intervals every 30,000 km (1,200 operating hours)

Clutch/transmission

  • Single-plate dry clutch, self-adjusting
  • 8 forward and 6 reverse gears
  • Rear-axle drive with pneumatically selectable all-wheel drive
  • Telligent® gearshift
  • Cruise control/speed limiter
  • Max. speed limiter 90 km/h
  • EQR (Electronic Quick Reverse)

Frame/axles

  • Flexible, ladder-type frame with high torsional flexibility
  • 3-point mountings for engine, transmission
  • Front towing jaw with pin
  • Coil springs with progressive characteristic line
  • Front/rear stabilizers
  • Portal axles, i = 6.53
  • Front/rear differential lock
  • Anti-corrosion underbody protection (Dinol)

Cab, exterior

  • All-steel short-bonnet cab, roof flap
  • Seat position behind the front axle
  • Short front end dimensions
  • Cab strength acc. to ECE R29/2
  • Bonnet tilts for maintenance
  • 3-point sprung-mounted cab with dampers
  • High, protected windscreen
  • 2 rear windows
  • Tinted glass all-round
  • Power windows
  • Windscreen washer system
  • Windscreen wipers with several speed settings and intermittent setting
  • Dust-free air intake at cab roof height
  • Non-slip steps with grab handle
  • Heated exterior mirrors, electrically adjustable

Cab, interior

  • Heating and ventilation system, 3-speed blower, residual engine heat utilization
  • Rest table and stowage compartments
  • Overhead console with 2 installation openings for radio/tachograph
  • Up to 3 sun visors
  • Center console with central controls, 1 installation opening
  • Combination switch on the steering column
  • Instrument cluster with analogue and LCD displays
  • On-board diagnostics
  • Hour meter
  • Seats with tailored backrest and integral head restraint
  • Driver’s seat adjustable for height and length, adjustable backrest
  • 3-point seat belts all around
  • Armrest in door trim
  • Interior lighting
  • Coat hook
  • Vehicle tools

Electrical system/lighting

  • 24 V vehicle power supply
  • Electronics box protected in the cab
  • 24 V outlet
  • CAN bus network
  • Rear trailer socket, 15-pin
  • Battery 66 Ah
  • Electronic vehicle management system
  • EMC-certified
  • Three-phase generator 28 V/100 A
  • Halogen headlamps
  • Headlamp range adjustment
  • Rear fog lamp
  • Reversing lights
  • End-outline marker lamps
  • Additional indicators

Braking system

  • Pneumatic/hydraulic high-pressure braking system (18 bar)
  • Disc brakes on all 4 wheels
  • 4-channel ABS, can be deactivated off-road
  • Automatic load-sensitive brake pressure control (ALB)
  • Compressed air connection for auxiliary loads
  • Spring-loaded parking brake
  • Tire inflation connection
  • Brake pad wear indicator
  • Air dryer

TECHNICAL DATA
Model – OM 904 LA | OM 924 LA

  • Emissions class – Euro 5
  • Type – 4-stroke diesel direct injection with turbocharger/intercooler
  • No. and arrangement of cylinders – 4, in-line
  • Max. output – 177 hp (130 kW) | 218 hp (160 kW)
  • At rated engine speed – 2,200 rpm
  • Max. torque – 675 Nm | 810 Nm
  • Displacement – 4,250 cc | 4,800 cc
  • Cooling system – Water with thermostat, 2 viscous fans with V-belt drive
  • Diesel fuel tank net capacity – 145 liters, with crewcab 160
  • AdBlue tank net capacity – 18 liters

Transmission

  • MB full-synchromesh reversing transmission with 8 forward and 6 reverse gears
  • Opt. additional 8 fully loadable working gears/off-road gears
  • Opt. electronic AutomaticShift system

Speeds with 335/80 R 20 tires and final drive ratio i = 6.53
Main gears – 6.6 – 85.7 km/h
Working gears – 1.1 – 14.9 km/h

Electrical system 24 V

  • Opt. battery 2 x 12 V/100 Ah, or 125 Ah
  • Opt. 24 V/25 A and 12 V/15 A outlets with C3 signals
  • Opt. 24 V/40 A equipment socket, 24-pin with C3/C4 signals

Steering

  • ZF Servocom hydraulic power steering, type 8095
  • Opt. right-hand drive
  • Opt. VarioPilot® transferable steering system
  • Turning circle Ø short wheelbase from 14.3 m
  • Turning circle Ø long wheelbase from 16.2 m

Axles/drive/frame

  • Portal axles connected to the transmission with torque tubes
  • Axle tube and differentials situated above wheel center line, high ground clearance
  • Standard-fit front/rear differential locks, all locks can be selected and deactivated electropneumatically while in motion using a dog clutch (100 % locking factor)
  • Standard fording capability up to 800 mm
  • Opt. fording system up to 1,200 mm fording depth
  • Opt. heat protection and mechanical protection for forest firefighting
  • Opt. frame extension, body length up to 4,600 mm possible

Cab
Exterior

  • Opt. crewcab for 7 persons
  • Opt. hydraulic tilt cab
  • Opt. heated windscreen
  • Opt. cab extended by 120 mm
  • Opt. round roof hatch
  • Opt. vertical exhaust pipe

Interior
Seats

  • Opt. driver and passenger seats as air-sprung luxury suspension seat
  • Opt. passenger seat as two-seater version; provides 3 seats
  • Opt. driver and passenger seats as air-sprung luxury suspension seat

Air conditioning

  • Integral air conditioning system or roof-mounted air conditioning system (also for crewcab)
  • Opt. auxiliary heating with engine preheating, 7-day timer

Instruments, controls

  • Driver information system (FIS) with status displays, event reports and menu-driven on-board diagnostics
  • 2-line indicator lamps, visual and acoustic warning indicators
  • Opt. digital tachograph

Safety

  • Safety locks in the doors, steering and ignition lock

Lighting

  • Opt. auxiliary headlamps with indicator lamps for implement operation
  • Opt. waterproof halogen fog lamps
  • Opt. rotating beacons

Wheels/tires

  • 4 identical size tires; single tires
  • Opt. low-pressure tires with MPT/AS treads
  • Standard tires 385/80 R 20
  • Smallest tires 335/80 R 20
  • Largest tires 425/75 R 20
  • Opt. tire pressure control system (tirecontrol) to adjust the tire pressure to on-road/off-road

Max. permissible loads
7.5 t Perm. GVW – 4.0 t (front axle), 4.4 t (rear axle)
8.5 t Perm. GVW – 4.0 t (front axle), 4.6 t (rear axle)
9.5 t Perm. GVW – 4.4 t (front axle), 5.3 t (rear axle)
10.0 t Perm. GVW – 4.5 t (front axle), 5.8 t (rear axle) only for firefighting

Towing capacity

  • Opt. dual-line trailer braking system
  • As truck up to 14.2 t, with center axle trailer up to 9 t

Hydraulics (optional)
Universal hydraulic system for positioning movements and continuous loads, implement manufacturer to supply req. Valves

    Single-circuit hydraulic system, with 60 l/min flow rate and 240 bar operating pressure
    Oil reservoir: 25 l (consumption quantity: 8 l)
    Can be controlled by equipment provided by implement supplier
    2 connectors front and rear

Auxiliary drives (optional)
Transmission-mounted auxiliary drive

Mechanical transmission-mounted auxiliary drive to power hydraulic pumps or similar

    High-speed PTO with i = 1.0
    Speed 2,200 rpm, rotates counter-clockwise in the direction of travel
    Max. torque 520 Nm
    Max. output 110 kW/120 kW depending on engine output
    OR
    Ultra-high-speed PTO with i = 0.61
    Speed 3,606 rpm, rotates to the right in direction of travel
    Max. torque 320 Nm
    Max. output 110 kW/120 kW depending on engine output

Implements and attachments (optional)

  • Front mounting plate acc. to DIN 76 060, type B, size 3
  • Frame attachment fittings/brackets, front and center; cable winch bracket
  • Floor assembly with twin 3-point cab mountings

Leave a Reply